Shanxian Chemical
SUPPLEMENTS
Clean Circuit Board Hydrogen Peroxide
"Cleaning Circuit Boards with Hydrogen Peroxide"
Circuit boards are the key to utensils and are related to their operation. However, as time goes by, dust and dirt accumulate gradually, or cause malfunctions. There is now a way to use hydrogen peroxide to clean them.
Hydrogen peroxide has strong oxidation properties and can remove fouling without damaging the circuit. Prepare an appropriate amount of hydrogen peroxide solution first. The concentration should be moderate. It should not be too strong and corrode the board, nor too weak and ineffective.
Lightly place the circuit board in a stable place, dip the hydrogen peroxide solution with a soft brush, and wipe it slowly. When wiping, pay attention to the strength, not too hard, to prevent damage to the circuit. In case of thick dirt, you can stop for a while, wait for the hydrogen peroxide to fully react with the dirt, and then brush.
After brushing, slowly rinse with water to remove its residual solution. After washing, place the circuit board in a well-ventilated place to let it dry naturally. Do not rush to dry, so as not to damage the circuit due to heat.
Clean the circuit board in this way, it can remove scale and dirt, and restore its refreshing and clean state, so that the utensils can run as before and run unimpeded.
Circuit boards are the key to utensils and are related to their operation. However, as time goes by, dust and dirt accumulate gradually, or cause malfunctions. There is now a way to use hydrogen peroxide to clean them.
Hydrogen peroxide has strong oxidation properties and can remove fouling without damaging the circuit. Prepare an appropriate amount of hydrogen peroxide solution first. The concentration should be moderate. It should not be too strong and corrode the board, nor too weak and ineffective.
Lightly place the circuit board in a stable place, dip the hydrogen peroxide solution with a soft brush, and wipe it slowly. When wiping, pay attention to the strength, not too hard, to prevent damage to the circuit. In case of thick dirt, you can stop for a while, wait for the hydrogen peroxide to fully react with the dirt, and then brush.
After brushing, slowly rinse with water to remove its residual solution. After washing, place the circuit board in a well-ventilated place to let it dry naturally. Do not rush to dry, so as not to damage the circuit due to heat.
Clean the circuit board in this way, it can remove scale and dirt, and restore its refreshing and clean state, so that the utensils can run as before and run unimpeded.
Scan to WhatsApp
